Routing and Switching Essentials Version 6 – RSE 6.0 Chapter 10 Exam

Routing and Switching Essentials (Version 6.00) – RSE 6.0 Chapter 10 Exam

QUESTION 1

A network administrator is explaining VTP configuration to a new technician. What should the network
administrator tell the new technician about VTP configuration? (Choose three.)

A.A switch in the VTP client mode cannot update its local VLAN database.
B.A trunk link must be configured between the switches to forward VTP updates.
C.A switch in the VTP server mode can update a switch in the VTP transparent mode.
D.A switch in the VTP transparent mode will forward updates that it receives to other switches.
E.A switch in the VTP server mode only updates switches in the VTP client mode that have a higher VTP
revision number.
F. A switch in the VTP server mode will update switches in the VTP client mode regardless of the
configured VTP domain membership.

Correct Answer: ABD
Section: (none)
Explanation
Explanation/Reference:

QUESTION 2

Refer to the exhibit. Both switches are using a default configuration. Which two destination addresses will
host 4 use to send data to host 1? (Choose two.)

A.the IP address of host 1
B.the IP address of host 4
C.the MAC address of host 1
D.the MAC address of host 4
E.the MAC address of the Fa0/0 interface of the R1 router
F. the MAC address of the Fa0/1 interface of the R1 router

Correct Answer: AF
Section: (none)
Explanation
Explanation/Reference:

QUESTION 3

What are two reasons a network administrator would use CDP? (Choose two.)

A.to verify the type of cable interconnecting two devices
B.to determine the status of network services on a remote device
C.to obtain VLAN information from directly connected switches
D.to verify Layer 2 connectivity between two devices when Layer 3 fails
E.to obtain the IP address of a connected device in order to telnet to the device
F. to determine the status of the routing protocols between directly connected routers

Correct Answer: DE
Section: (none)
Explanation
Explanation/Reference:

QUESTION 4

Refer to the exhibit. The router has been configured with these commands:

What are the two results of this configuration? (Choose two.)

A.The default route should have a next hop address of 64.100.0.3.
B.Hosts on the LAN that is connected to FastEthernet 0/1 are using public IP addressing.
C.The address of the subnet segment with the WWW server will support seven more servers.
D.The addressing scheme allows users on the Internet to access the WWW server.
E.Hosts on the LAN that is connected to FastEthernet 0/1 will not be able to access the Internet without address translation.

Correct Answer: DE
Section: (none)
Explanation
Explanation/Reference:

QUESTION 5

A company is installing IP phones. The phones and office computers connect to the same device. To
ensure maximum throughput for the phone data, the company needs to make sure that the phone traffic is
on a different network from that of the office computer data traffic. What is the best network device to which
to directly connect the phones and computers, and what technology should be implemented on this device? (Choose two.)

A.hub
B.router
C.switch
D.STP
E.subinterfaces
F. VLAN

Correct Answer: CF
Section: (none)
Explanation
Explanation/Reference:

QUESTION 6

What are two benefits of using VTP in a switching environment? (Choose two.)

A.It allows switches to read frame tags.
B.It allows ports to be assigned to VLANs automatically.
C.It maintains VLAN consistency across a switched network.
D.It allows frames from multiple VLANs to use a single interface.
E.It allows VLAN information to be automatically propagated throughout the switching environment.

Correct Answer: CE
Section: (none)
Explanation
Explanation/Reference:

QUESTION 7

Which two statements are true about the command ip route 172.16.3.0 255.255.255.0 192.168.2.4? (Choose two.)

A.It establishes a static route to the 172.16.3.0 network.
B.It establishes a static route to the 192.168.2.0 network.
C.It configures the router to send any traffic for an unknown destination to the 172.16.3.0 network.
D.It configures the router to send any traffic for an unknown destination out the interface with the address 192.168.2.4.
E.It uses the default administrative distance.
F. It is a route that would be used last if other routes to the same destination exist.

Correct Answer: AE
Section: (none)
Explanation
Explanation/Reference:

QUESTION 8

What are two advantages of Layer 2 Ethernet switches over hubs? (Choose two.)

A.decreasing the number of collision domains
B.filtering frames based on MAC addresses
C.allowing simultaneous frame transmissions
D.increasing the size of broadcast domains
E.increasing the maximum length of UTP cabling between devices

Correct Answer: BC
Section: (none)
Explanation
Explanation/Reference:

QUESTION 9

Refer to the exhibit. A network associate needs to configure the switches and router in the graphic so that
the hosts in VLAN3 and VLAN4 can communicate with the enterprise server in VLAN2. Which two Ethernet
segments would need to be configured as trunk links? (Choose two.)

A.A
B.B
C.C
D.D
E.E
F. F

Correct Answer: CF
Section: (none)
Explanation
Explanation/Reference:

QUESTION 10

Which two values are used by Spanning Tree Protocol to elect a root bridge? (Choose two.)

A.amount of RAM
B.bridge priority
C.IOS version
D.IP address
E.MAC address
F. speed of the links

Correct Answer: BE
Section: (none)
Explanation
Explanation/Reference:

QUESTION 11

Refer to the exhibit. The networks connected to router R2 have been summarized as a 192.168.176.0/21
route and sent to R1. Which two packet destination addresses will R1 forward to R2? (Choose two.)

A.192.168.194.160
B.192.168.183.41
C.192.168.159.2
D.192.168.183.255
E.192.168.179.4
F. 192.168.184.45

Correct Answer: BE
Section: (none)
Explanation
Explanation/Reference:

QUESTION 12

Which three statements are typical characteristics of VLAN arrangements? (Choose three.)

A.A new switch has no VLANs configured.
B.Connectivity between VLANs requires a Layer 3 device.
C.VLANs typically decrease the number of collision domains.
D.Each VLAN uses a separate address space.
E.A switch maintains a separate bridging table for each VLAN.
F. VLANs cannot span multiple switches.

Correct Answer: BDE
Section: (none)
Explanation
Explanation/Reference:

QUESTION 13

Refer to the exhibit. Which three statements are true about how router JAX will choose a path to the
10.1.3.0/24 network when different routing protocols are configured? (Choose three.)

A.By default, if RIPv2 is the routing protocol, only the path JAX-ORL will be installed into the routing table.
B.The equal cost paths JAX-CHI-ORL and JAX- NY-ORL will be installed in the routing table if RIPv2 is
the routing protocol.
C.When EIGRP is the routing protocol, only the path JAX-ORL will be installed in the routing table by default.
D.When EIGRP is the routing protocol, the equal cost paths JAX-CHI-ORL, and JAX-NY-ORL will be
installed in the routing table by default.
E.With EIGRP and OSPF both running on the network with their default configurations, the EIGRP paths
will be installed in the routing table.
F. The OSPF paths will be installed in the routing table, if EIGRP and OSPF are both running on the
network with their default configurations.

Correct Answer: ADE
Section: (none)
Explanation
Explanation/Reference:

QUESTION 14

Refer to the exhibit. Which three statements correctly describe Network Device A? (Choose three.)

A.With a network wide mask of 255.255.255.128, each interface does not require an IP address.
B.With a network wide mask of 255.255.255.128, each interface does require an IP address on a unique IP subnet.
C.With a network wide mask of 255.255.255.0, must be a Layer 2 device for the PCs to communicate with each other.
D.With a network wide mask of 255.255.255.0, must be a Layer 3 device for the PCs to communicate with each other.
E.With a network wide mask of 255.255.254.0, each interface does not require an IP address.

Correct Answer: BDE
Section: (none)
Explanation
Explanation/Reference:

QUESTION 15

Switch ports operating in which two roles will forward traffic according to the IEEE 802.1w standard?

(Choose two.)
A.alternate
B.backup
C.designated
D.disabled
E.root

Correct Answer: CE
Section: (none)
Explanation
Explanation/Reference:

Add Comment