Routing and Switching Essentials Version 6 – RSE Practice Final

Routing and Switching Essentials (Version 6.00) – RSE Practice Final

QUESTION 1

Refer to the exhibit. Given the output shown from this Cisco Catalyst 2950, what is the most likely reason
that interface FastEthernet 0/10 is not the root port for VLAN 2?

A.This switch has more than one interface connected to the root network segment in VLAN 2.
B.This switch is running RSTP while the elected designated switch is running 802.1d Spanning Tree.
C.This switch interface has a higher path cost to the root bridge than another in the topology.
D.This switch has a lower bridge ID for VLAN 2 than the elected designated switch.

Correct Answer: C
Section: (none)
Explanation
Explanation/Reference:

QUESTION 2

Refer to the exhibit. This command is executed on 2960Switch:
2960Switch(config)# mac-address-table static 0000.00aa.aaaa vlan 10 interface fa0/1
Which two of these statements correctly identify results of executing the command? (Choose two.)

A.Port security is implemented on the fa0/1 interface.
B.MAC address 0000.00aa.aaaa does not need to be learned by this switch.
C.Only MAC address 0000.00aa.aaaa can source frames on the fa0/1 segment.
D.Frames with a Layer 2 source address of 0000.00aa.aaaa will be forwarded out fa0/1.
E.MAC address 0000.00aa.aaaa will be listed in the MAC address table for interface fa0/1 only.

Correct Answer: BE
Section: (none)
Explanation
Explanation/Reference:

QUESTION 3

Which of the following describes the roles of devices in a WAN? (Choose three.)

A.A CSU/DSU terminates a digital local loop.
B.A modem terminates a digital local loop.
C.A CSU/DSU terminates an analog local loop.
D.A modem terminates an analog local loop.
E.A router is commonly considered a DTE device.
F. A router is commonly considered a DCE device.

Correct Answer: ADE
Section: (none)
Explanation
Explanation/Reference:

QUESTION 4

What are two characteristics of Telnet? (Choose two.)

A.It sends data in clear text format.
B.It is no longer supported on Cisco network devices.
C.It is more secure than SSH.
D.It requires an enterprise license in order to be implemented.
E.It requires that the destination device be configured to support Telnet connections.

Correct Answer: AE
Section: (none)
Explanation
Explanation/Reference:

QUESTION 5

What are two security appliances that can be installed in a network? (Choose two.)

A.ATM
B.IDS
C.IOS
D.IOX
E.IPS
F. SDM

Correct Answer: BE
Section: (none)
Explanation
Explanation/Reference:

QUESTION 6

Assuming a subnet mask of 255.255.248.0, three of the following addresses are valid host addresses.
Which are these addresses? (Choose three.)

A.172.16.9.0
B.172.16.8.0
C.172.16.31.0
D.172.16.20.0

Correct Answer: ACD
Section: (none)
Explanation
Explanation/Reference:

QUESTION 7

Refer to the exhibit. A network technician is unable to ping from R1 to R2.
What will help correct the problem?

A.Ensure that the serial cable is correctly plugged in to the interfaces.
B.Apply the clock rate 56000 configuration command to the serial0/1 interface of R1.
C.Configure the serial0/1 interfaces on R1 and R2 with the no shutdown command.
D.Change the address of the serial0/1 interface of R1 to 192.1.1.4.
E.Change the subnet masks of both interfaces to 255.255.255.240.

Correct Answer: A
Section: (none)
Explanation
Explanation/Reference:

QUESTION 8

Refer to the exhibit. Which two statements are true of the interface configuration? (Choose two.)

A.The encapsulation in use on this interface is PPP.
B.The default serial line encapsulation is in use on this interface.
C.The address mask of this interface is 255.255.255.0.
D.This interface is connected to a LAN.
E.The interface is not ready to forward packets.

Correct Answer: AC
Section: (none)
Explanation
Explanation/Reference:

QUESTION 9

Refer to the exhibit. What does the address 192.168.2.167 represent?

A.the TFTP server from which the file startup-config is being transferred
B.the router from which the file startup-config is being transferred
C.the TFTP server from which the file router-confg is being transferred
D.the TFTP server to which the file router-confg is being transferred
E.the router to which the file router-confg is being transferred
F. the router to which the file startup-config is being transferred

Correct Answer: D
Section: (none)
Explanation
Explanation/Reference:

QUESTION 10

Refer to the exhibit. A technician is troubleshooting a host connectivity problem. The host is unable to ping a
server connected to Switch_A.
Based on the results of the testing, what could be the problem?

A.A remote physical layer problem exists.
B.The host NIC is not functioning.
C.TCP/IP has not been correctly installed on the host.
D.A local physical layer problem exists.

Correct Answer: D
Section: (none)
Explanation
Explanation/Reference:

QUESTION 11

In which situation would the use of a static route be appropriate?

A.To configure a route to the first Layer 3 device on the network segment.
B.To configure a route from an ISP router into a corporate network.
C.To configure a route when the administrative distance of the current routing protocol is too low.
D.To reach a network is more than 15 hops away.
E.To provide access to the Internet for enterprise hosts.

Correct Answer: B
Section: (none)
Explanation
Explanation/Reference:

QUESTION 12

An administrator issues the show ip interface s0/0 command and the output displays that interface Serial0/0
is up, line protocol is up What does “line protocol is up” specifically indicate about the interface?

A.The cable is attached properly.
B.CDP has discovered the connected device.
C.Keepalives are being received on the interface.
D.A carrier detect signal has been received from the connected device.
E.IP is correctly configured on the interface.

Correct Answer: C
Section: (none)
Explanation
Explanation/Reference:

QUESTION 313

Which three statements are correct about RIP version 2? (Choose three)

A.It uses broadcast for its routing updates
B.It supports authentication
C.It is a classless routing protocol
D.It has a lower default administrative distance than RIP version 1
E.It has the same maximum hop count as version 1
F. It does not send the subnet mask un updates

Correct Answer: BCE
Section: (none)
Explanation
Explanation/Reference:

QUESTION 314

How can an administrator determine if a router has been configured when it is first powered up?

A.A configured router prompts for a password.
B.A configured router goes to the privileged mode prompt.
C.An unconfigured router goes into the setup dialog.
D.An unconfigured router goes to the enable mode prompt.

Correct Answer: C
Section: (none)
Explanation
Explanation/Reference:

QUESTION 15

Drag and Drop Question

A.
B.
C.
D.
Correct Answer:
Section: (none)
Explanation
Explanation/Reference:

Add Comment